Tdk A360 Wireless - Battery replacement instructions Uživatelský manuál stáhnout pdf

TREK 360 Battery Replacement Instructions

Caution: Disconnect the TREK 360 power and place the power switch on the rear

of the unit in the OFF position before beginning the replacement.

1. Place the unit on its left side. Using a

T-5 Torx driver, remove the four screws

holding the battery cover plate.

2. Place the unit upright. With a

jeweler’s screwdriver or a tweezers,

carefully pry out the battery cover

plate.

3. The battery compartment.

1 2 3

Strany 1

TREK 360 Battery Replacement Instructions Caution: Disconnect the TREK 360 power and place the power switch on the rear of the unit in the OFF posit

4. Using a screw driver, lift on the lower corner of the battery assembly and rotate upwards. The battery will not lift straight up. 5. Lif

7. Remove the old battery and insert the replacement. 8. Plug in the connector, press the cable in place and replace the battery cover. 9. Reins

Žádné komentáře

Tdk A360 Wireless - Battery replacement instructions Uživatelský manuál